AutomationTechBrian
Lifetime Supporting Member
I can't get the encoder pulses to show up on the function block when I'm in "de-bugging" mode, which is the on-line mode of the software. I suspect it could be the encoder that I'm using. It only has 3 wires, +vdc, com, and A. I'm using a simple "count-up" UDFB. I can see the values change when I enable the counter, and when I "start" the counter, but the "Accumulator" variable stays at 0 when I'm turning the shaft.
More info:
Slot ID: 2
Noise...: 00 (no filter)
Mode: 0
There is so little info on the internet about this card. Can anyone help? I'm very frustrated, and the customer is losing patience. Thanks!
Brian
More info:
Slot ID: 2
Noise...: 00 (no filter)
Mode: 0
There is so little info on the internet about this card. Can anyone help? I'm very frustrated, and the customer is losing patience. Thanks!
Brian