THank you guys,
I ordered the end cap few days ago and
I received the 1769-ECR yesterday.
I put the end cap on the PLC and I try to run my program, but I have always the same error....
Moreover On the modules, the error says :
I didn't change my program, what do I do ?
Thank you very much
I ordered the end cap few days ago and
I received the 1769-ECR yesterday.
I put the end cap on the PLC and I try to run my program, but I have always the same error....
(Type 03) I/O Fault (Code 23) “At least one required connection was not established before going into Run mode."
Moreover On the modules, the error says :
(Code16#0203) Connection timed out
I didn't change my program, what do I do ?
Thank you very much
Last edited: