Axis Positionning S7-1200 and asynchronous motor

JEANST

Member
J
Join Date
Jun 2015
Location
PARIS
Posts
68
Hello Dear Experts
Is anyone knows where i can find some example to make some positionning function with S7-1200 Motion Control (v7.0) functions and asynchronous motor
below is my configuration

S7-1214 (tia v16)
Motion control v7.0
Frequency controller ATV31
Command frequency controller via analog output (Signal board)
Encoder via HSC_1
I use Telegram 1 via DataBlock for communication with the atv31 as it have no Profidrive capabilities.

Thanks for your help
 

Similar Topics

V
Micro850 + Sensor: 1 Axis can not move in negative direction when working together with sensor
Hi everyone, I am working with micro850, a proximity sensor (FOTEK, PL-05P) and a 3DOF serial arm robot. I use MC_MoveRelative to control the...
Replies
1
Views
62
vhs
V
D
Studio 5000 v33 Emulate PLC & HMI with Motion Axis
Hello Experts, I'm wondering if this has been done before if possible to create an Emulate file that have motion control axis? I tried to...
Replies
0
Views
151
DenZ_P
D
M
Axis command position keep dropping down to -2000
Hey guys, I got a carriage that can move with X and Y axe, each side got their own cylinder so left and right. It doesnt happen very often but...
Replies
0
Views
328
Martindag
M
P
B&R Automation PC 910 Maximum number of axis?
Hi PLCs.net! I was curious: How many axis can a B&R APC910 control? Is there a hard limit like certain AB controllers? I'm new to B&R, so would...
Replies
0
Views
371
PreLC
P
S
Simple XY movements using FWD RE and stop commands on each axis
Hi all! I am using unitronics Unistream plc, controlling two axis X and Y of polishing machine. Control is very simple as I have movement in each...
2 3
Replies
34
Views
3,961
SonusI
S
Back
Top Bottom