help!!!!
using a 1734 232asc point i/o module over devicenet back to a sdn module in the plc5 rack....
reading barcode back to a plc 5 (sdn to plc5)
have 1734 configured and mapped as best as i can
mapped back to a block xfer in the plc5 but to a n9 file which when i scan it reads all messed up unless i tab on ascii in rslogix than it looks o.k.
so whats the trick to getting the barcode to look right in the data table so i can move it to a "temp b" file which later will tie two barcodes together
right now all this is done by a business system and its being removed (sql server)
need help desperatly!!!!!
project is due and i am stressing
any and all help is greatly appreciated
hope everyone had a nice holiday
thanks
bernie
using a 1734 232asc point i/o module over devicenet back to a sdn module in the plc5 rack....
reading barcode back to a plc 5 (sdn to plc5)
have 1734 configured and mapped as best as i can
mapped back to a block xfer in the plc5 but to a n9 file which when i scan it reads all messed up unless i tab on ascii in rslogix than it looks o.k.
so whats the trick to getting the barcode to look right in the data table so i can move it to a "temp b" file which later will tie two barcodes together
right now all this is done by a business system and its being removed (sql server)
need help desperatly!!!!!
project is due and i am stressing
any and all help is greatly appreciated
hope everyone had a nice holiday
thanks
bernie