Saurabh Trivedi
Member
Hello all, we are using beckhoff twincat system 2.9 in which we have added a motion axis in one machine after the final machine installtion.
We were facing a very common problem in that machine that whenever there is sudden power failure, one axis which we had added stops moving.
And we have to replace the IPC's hard disk every time this problem comes.
This particular problem is coming only in one machine in which we had added motion axis by ourself.
The drive which we were using in beckhoff AX2003.
So is anything we have missed during creating or saving the program ?
We were facing a very common problem in that machine that whenever there is sudden power failure, one axis which we had added stops moving.
And we have to replace the IPC's hard disk every time this problem comes.
This particular problem is coming only in one machine in which we had added motion axis by ourself.
The drive which we were using in beckhoff AX2003.
So is anything we have missed during creating or saving the program ?