Hello,
I want to configure AB 1756-ENBT ethernet module using BootP software. I connected my PC directly via cross cable once and via straight cable second time to the ethernet module that installed on the 1756-A7 chassis and opened BootP program and set the mask net to 255.255.255.0 and I followed the steps mentioned in AB manual but the MAC address and any thing of the module not showed in the BootP program.
How I should connect my PC to the ethernet module to set the IP address using BootP. Is there need to do any configuration for the PC. A diagram or scrren shoot will be helpfull.
Thanks
I want to configure AB 1756-ENBT ethernet module using BootP software. I connected my PC directly via cross cable once and via straight cable second time to the ethernet module that installed on the 1756-A7 chassis and opened BootP program and set the mask net to 255.255.255.0 and I followed the steps mentioned in AB manual but the MAC address and any thing of the module not showed in the BootP program.
How I should connect my PC to the ethernet module to set the IP address using BootP. Is there need to do any configuration for the PC. A diagram or scrren shoot will be helpfull.
Thanks