Clamp on Shaft Tach

Sparkie- the results will be graphed over hours. Its not an immediate thing that I'm looking for

Tom- got a photoprox and found that since its light (no pun intended) I can place it in position with a flexible dial indicator stand. Gotta write a little RPM code in the PLC and we should be good do go.

Thanks all for the help.
 

Similar Topics

B
Clamp on shaft encoders or speed sensors
Good Morning , We have a large machine with a number of shafts , and I would like to monitor those to make sure they are constantly...
Replies
6
Views
2,141
geniusintraining
geniusintraining
J
10 volt clamp
Good afternoon, This one may sound crazy. I have a device that is configured to outputs a 0 to 10 volt signal. the scaling is 0 - 0 and 10 -...
Replies
4
Views
1,660
Mickey
Mickey
J
TwinCAT 3 - RS232 Serial Communication - EL6002 Clamp
Good morning everyone, This is my first post here. I am beginning my journey on PLC programming and still a really newbie, I want to write a...
Replies
0
Views
1,265
jbmelo91
J
Ken Moore
OT: Fluke 771 Milliamp Process Clamp Meter-Alternatives.
So... Long story short, some of our electricians struggle when asked to measure loops. A clamp on meter resolves this. The Fluke 771 is a great...
2
Replies
22
Views
6,613
mylespetro
mylespetro
B
PIDE CLamp
I have a boiler with a max steam flow. is there away to Clamp the CV value whenever the Steam output goes over 40000 PPH My PIDe is controlling...
Replies
6
Views
2,088
rupej
R
Back
Top Bottom