HI All
I have a CLX device net network with Power flex drives, Smart guard 600, Festio CLX valve blocks, POint I/O etc. I have set them all up in the sscan list, mapped the I/O and placed the card into run mode no proble.
I can see the Epson RC 90 robot controller as a Unrecognized devicet and I understand this as I have never set one up before. I use the wizard to import the EDS file from epson and
I get a error saying that it is not the correct file. I have contacted EPSON and they say I have the correct file. I then tried to create a EDS file using the wizard and I get the following errors.
The following error occurred in the [File] section of the EDS file: The Revision entry is not a valid revision
and
****The following errors and/or warnings were encountered during the processing of the EDS file for the 'EPSON RC620 DeviceNet Slave' product. ****
any help would be great.
Donnchadh
I have a CLX device net network with Power flex drives, Smart guard 600, Festio CLX valve blocks, POint I/O etc. I have set them all up in the sscan list, mapped the I/O and placed the card into run mode no proble.
I can see the Epson RC 90 robot controller as a Unrecognized devicet and I understand this as I have never set one up before. I use the wizard to import the EDS file from epson and
I get a error saying that it is not the correct file. I have contacted EPSON and they say I have the correct file. I then tried to create a EDS file using the wizard and I get the following errors.
The following error occurred in the [File] section of the EDS file: The Revision entry is not a valid revision
and
****The following errors and/or warnings were encountered during the processing of the EDS file for the 'EPSON RC620 DeviceNet Slave' product. ****
any help would be great.
Donnchadh