Hi
I am having problems with coms from the PLC to a IPC 577 c device with Win CC Flex 2008 as my SCADA program.
I can download to the device but no indicators come on.
When I set up the WinCC project from my laptop everything works fine.
When I setup the IPC 577c in Netpro I used a onboard CP 1616 device, is this correct or is this an add-on card?
Is there anything else I must setup on the IPC Device for coms?
Please advice
I am having problems with coms from the PLC to a IPC 577 c device with Win CC Flex 2008 as my SCADA program.
I can download to the device but no indicators come on.
When I set up the WinCC project from my laptop everything works fine.
When I setup the IPC 577c in Netpro I used a onboard CP 1616 device, is this correct or is this an add-on card?
Is there anything else I must setup on the IPC Device for coms?
Please advice