Hey,
I'm having a strange error on a PLC 5/40B Series D Rev B. I am trying to set the channel 0 configuration from "system (Point-to-Point)" to "System (Master)" When I do this, and hit apply/ok, it pops up an error box which says "Configuration Edits not accepted by PLC..." and that's it. Anyone know why?
I checked to make sure that my firmware supports this function, and according to AB doc# G19099 I do have support.
Any ideas?
Wes Lemstra
I'm having a strange error on a PLC 5/40B Series D Rev B. I am trying to set the channel 0 configuration from "system (Point-to-Point)" to "System (Master)" When I do this, and hit apply/ok, it pops up an error box which says "Configuration Edits not accepted by PLC..." and that's it. Anyone know why?
I checked to make sure that my firmware supports this function, and according to AB doc# G19099 I do have support.
Any ideas?
Wes Lemstra