Connection ????
- Thread starter deand
- Start date
Ken Roach
Lifetime Supporting Member + Moderator
In general, no. Definitely not with the PanelView Classic, Enhanced, or Standard terminals.
It's not a feature that RA even intended the devices to have, but sometimes you can browse through a PanelView Plus serial port to the connected DH+ or ControlNet network. If you have both a DF1 Full Duplex driver and the network driver configured, the virtual backplane object will accept browse commands and pass them through to the other network.
You can't effectively go online or perform other functions, but sometimes it's possible to browse.
It's not a feature that RA even intended the devices to have, but sometimes you can browse through a PanelView Plus serial port to the connected DH+ or ControlNet network. If you have both a DF1 Full Duplex driver and the network driver configured, the virtual backplane object will accept browse commands and pass them through to the other network.
You can't effectively go online or perform other functions, but sometimes it's possible to browse.
Similar Topics
Hello all!
So I have one project with a S7-1214 and a MTP1500 "Project1" and one project with another S7-1214 "Project2".
Both of these PLC:s need...
Hi dear . I have a system with cj1m cpu11 etn. previously NT 5z HMI was connected with plc. recently my old HMI got damaged. I want to replace it...
Hello gentlemen,
Im working on a small project on TIA Portal, about establishing a Modbus TCP connection between my ET200SP plc and a socomec...
Hi all,
My ethernet port on my laptop recently broke and I was hoping to just use a usb-c dongle in the mean time to go live on my PLC until I...
Not a PLC question but I need expert help on this.
My FactoryTalk stopped communicating with the server its hosted on. I had an error stating...