panel1
Member
I have an older program that needs to be revised.I'am not familiar with the Syswin 3.4 software at all. This is my first time programming on the Omron. Any help with the below request would be greatly appreciated. I'm sure there are people who can make this change very quickly. The current program attached is for sequencing 6 pumps. The sequence (shift) occurs when all pumps are off. I want to change this to select either bank 1 (pumps 1,2,3)or bank 2 (pumps 4,5,6,). I will add an input switch to select either bank one or bank two on my control panel. When bank 1 is selected pumps will operate in a 1,2,3...2,3,1...3,1,2 sequence. Pumps 4,5,6 will remain off until bank two is selected. They will then follow the same sequence as bank one did. The lag alarm will no longer sound when two pumps are running. It will be triggered when plant pressure equals setpoint on compare. The current attached program allows for all six outputs to be sequenced. The other problem is I do not have an Omron PLC in house to test this program. I have a 100 mile drive to do my testing and debugging. Any help is greatly appreciated. Thanks in advance.