califflash
Member
I am doing some development on a new HMI database on a G310C210. I was updating incremental changes on my test unit just fine and now I cannot update my unit over USB or Ethernet.
Normally when I plug the unit into my computer via the device port windows automatically recognizes the g3 and lets me download to it. It no longer does this. I held down the 1st and 2nd soft keys during power up and cleared the database and I still cannot connect.
I then reconfigured the IP address settings and attempted to update via ethernet. I get an error stating that Crimson cannot open the communications port.
Finally, I tried all this again with a different, known to be working computer. I can ping the g3 panel but just can't download to it.
Has anyone else seem similar behavior?
Normally when I plug the unit into my computer via the device port windows automatically recognizes the g3 and lets me download to it. It no longer does this. I held down the 1st and 2nd soft keys during power up and cleared the database and I still cannot connect.
I then reconfigured the IP address settings and attempted to update via ethernet. I get an error stating that Crimson cannot open the communications port.
Finally, I tried all this again with a different, known to be working computer. I can ping the g3 panel but just can't download to it.
Has anyone else seem similar behavior?