Hi there,
Quick question, I think I am thinking about this too much.
I want to activate a timer for lets say 10 minutes when a contact produces a high signal. After the timer starts I don't want to the timer to be reset until it is finished (I.E. If the signal goes low after 3 minutes.) , and then I want to reset the timer. Is there a simple way to do this?
Thanks!
Quick question, I think I am thinking about this too much.
I want to activate a timer for lets say 10 minutes when a contact produces a high signal. After the timer starts I don't want to the timer to be reset until it is finished (I.E. If the signal goes low after 3 minutes.) , and then I want to reset the timer. Is there a simple way to do this?
Thanks!