I would like to request everyone's help so i can enjoy the holiday seasons.
Our PLC for our Ship Unloader (Allen Bradley) suddenly lost all controls and we suspected that there might have been problems on our devicenet which has 3 converters, 1 ASI Module and 1 Cavotec Base (for Radio remote controller, E010 "no plc communication" error)
We have restored the communication and controls with the 3 converters and 1 ASI module but we have trouble regarding the Cavotec base radio since it could be detected by RSlinx but not in RSNetworkx (Dnet). With this we cannot resume operations due to this problem.
The devicenet is connected to the Anybus Devicenet (by HMS networks) Interface in the radio base unit
So I would like to request advise on how to configure so the Anybus could communicate with the PLC
It's been a week that we have been facing this dilemma.
Our PLC for our Ship Unloader (Allen Bradley) suddenly lost all controls and we suspected that there might have been problems on our devicenet which has 3 converters, 1 ASI Module and 1 Cavotec Base (for Radio remote controller, E010 "no plc communication" error)
We have restored the communication and controls with the 3 converters and 1 ASI module but we have trouble regarding the Cavotec base radio since it could be detected by RSlinx but not in RSNetworkx (Dnet). With this we cannot resume operations due to this problem.
The devicenet is connected to the Anybus Devicenet (by HMS networks) Interface in the radio base unit
So I would like to request advise on how to configure so the Anybus could communicate with the PLC
It's been a week that we have been facing this dilemma.