Digital Open Circuit
- Thread starter asterof
- Start date
Mickey
Lifetime Supporting Member
See manual below page 4-15
http://literature.rockwellautomation.com/idc/groups/literature/documents/um/1756-um058_-en-p.pdf
http://literature.rockwellautomation.com/idc/groups/literature/documents/um/1756-um058_-en-p.pdf
danw
Lifetime Supporting Member
In the current version (F, April 2012) manual at the link above, open wire detection is on page 73.
Only the "Diagnostic" modules have wire-break detection.
Suffix "D" is on the part number, e.g. 1756-IB16D, and the word DIAGNOSTIC is on the front on the module, just below the display window.
If it's a standard module, e.g. 1756-IB16, it does not have wire-break detection.
Similar Topics
Hello,
I'm looking for a dirt cheap digital display + input, that would be wired to an analog input and analog output.
This would be for my home...
Question to anyone with ideas about my thoughts on upgrading a very vintage timer, which is being used to switch between 2 5hp domestic water...
I have a PLC type PM856 from ABB with some I/O modules and I get an error from the Digital Inputs model type DI801.
The unit status shows error...
I am monitoring two BMXDDO3202K digital outputs for their behaviour, they are each for opening and closing, and so the on time affects how far the...
On the laser displacement sensor now connected to my PLC, the manual says 4mA=643 and 20mA=64,877.
However, I checked with a Fluke, injecting...
