cnrservices
Member
Thanks Guys,
If I got this right - Stage S0 isn't shut off or called anywhere else in the program so it must always run every scan. Or not?
If I put the timer to check X11 in SO and then replace all XIC X11 with XIC my timer Done this should work?
marksji,
If some input or program code turned off S22 without me adding any calls to stages would this cause a CPU fault - and stop the PLC communicating with Directsoft, unable to check error, clear fault, change mode, etc.? (Remember - on 2 different CPU's, but the same edit worked fine in another stage.)
Again, thanks for all the input.
If I got this right - Stage S0 isn't shut off or called anywhere else in the program so it must always run every scan. Or not?
If I put the timer to check X11 in SO and then replace all XIC X11 with XIC my timer Done this should work?
marksji,
If some input or program code turned off S22 without me adding any calls to stages would this cause a CPU fault - and stop the PLC communicating with Directsoft, unable to check error, clear fault, change mode, etc.? (Remember - on 2 different CPU's, but the same edit worked fine in another stage.)
Again, thanks for all the input.