I made a hardware configuration and I used IM151-8 PN Cpu and connected two ET200S stations (IM151-3).When I want transfer to ET200S first.I am using Simatic Manager V5.5 SP3 ( operate 64 bit Windows 7 ultimate).There is a Assign device name window in the Simatic Manager.but Assign device name button is inactive.Therefore I could not transfer to ET200S stations.The other problem I want to transfer hardware program to IM151-8 PN Cpu,This message is showing.Online:Cannot load the selected communication driver;File not found.Set PG/PC interface is S7ONLINE (STEP 7)--->Realtek PCle GBE Family Controller.TCPIP.Auto (Active).And in Diagnostic window Test button pressed.SR Protocol status '' access points using this paramter set:
->S7ONLINE''.I tried again but no success.And finally I uninstalled STEP-7 and installed again but no success.Is there any experience?Thanks in advance..
->S7ONLINE''.I tried again but no success.And finally I uninstalled STEP-7 and installed again but no success.Is there any experience?Thanks in advance..