Hi,
I have a Siemens CPU 315-2DP and want to replace a 2-wire card (134-4GB01-0AB0). This card is mounted on a "ET 200S (IM151)" according to HW config.
Is it correct that I can not hot swap this card? What will happen if I do?
I have OB82 and OB86 but this link says I must have IM153:
https://support.industry.siemens.com/cs/#document/1826766/how-do-you-configure-the-%22change-module-during-operation%22-and-the-%22removeplug-alarm%22-functions-in-an-et-200m?dti=0&lc=en-WW
Other people just say "yes you can how swap on ET200S", but don't say anything about IM-version.
Must I power down the whole IO-node, replace, and then power up? It looks easy to just remove the card and insert a new one but I rather power down the profibus node if I must, compared to stop the whole PLC by misstake.
I have a Siemens CPU 315-2DP and want to replace a 2-wire card (134-4GB01-0AB0). This card is mounted on a "ET 200S (IM151)" according to HW config.
Is it correct that I can not hot swap this card? What will happen if I do?
I have OB82 and OB86 but this link says I must have IM153:
https://support.industry.siemens.com/cs/#document/1826766/how-do-you-configure-the-%22change-module-during-operation%22-and-the-%22removeplug-alarm%22-functions-in-an-et-200m?dti=0&lc=en-WW
Other people just say "yes you can how swap on ET200S", but don't say anything about IM-version.
Must I power down the whole IO-node, replace, and then power up? It looks easy to just remove the card and insert a new one but I rather power down the profibus node if I must, compared to stop the whole PLC by misstake.
Last edited: