CENTER
Lifetime Supporting Member
I have a question on an install I did last week one of you guys may be able to help me out with. I don’t have all the model #s of the PLC and HMI with me so this more of a generic question.
I have a MICROLOGIX 1400 a PanelView plus 1500 HMI (I do remember the mer. was 10) and 2 diameter gauges that I message from the 1400. I also have a Stratix 2000 switch.
The problem I am having is on boot up I have no comms until I disconnect the 2 diameter controllers, the HMI connects I plug in the diameter controls and we are back in business. During the time when I have no comms, I can ping the HMI, PLC, and the 2 diameter controlers and can see every thing in LINKS. Any ideas would be appreciated.
I have a MICROLOGIX 1400 a PanelView plus 1500 HMI (I do remember the mer. was 10) and 2 diameter gauges that I message from the 1400. I also have a Stratix 2000 switch.
The problem I am having is on boot up I have no comms until I disconnect the 2 diameter controllers, the HMI connects I plug in the diameter controls and we are back in business. During the time when I have no comms, I can ping the HMI, PLC, and the 2 diameter controlers and can see every thing in LINKS. Any ideas would be appreciated.