Hi,
I have to replace an old Exor Tline HMI with a siemens HMI. I was able to upload the project from the HMI but it appears to have not uploaded the configuration of the physical buttons on the screen. For example F1, F2 etc.
Is there any tricks to this?
The only information I can give right now is that is is monochrome, says Tline EXOR R&D and uses a serial port to communicate to an Omron C200H processor.
I put it in configuration mode and uploaded it using UniOP Designer 6.10
Everything seems to be there except the key assignments?
They use these a fair bit so it would be helpful to know what they where doing?
Thanks,
I have to replace an old Exor Tline HMI with a siemens HMI. I was able to upload the project from the HMI but it appears to have not uploaded the configuration of the physical buttons on the screen. For example F1, F2 etc.
Is there any tricks to this?
The only information I can give right now is that is is monochrome, says Tline EXOR R&D and uses a serial port to communicate to an Omron C200H processor.
I put it in configuration mode and uploaded it using UniOP Designer 6.10
Everything seems to be there except the key assignments?
They use these a fair bit so it would be helpful to know what they where doing?
Thanks,