rankhornjp
Member
I'm not an AB guy, I usually work with Schneider/Modicon.
Here's what I have:
Controller: ControlLogix 5562, 1765-L62
Software: RSLogix 5000
Revision: 20.11
I have a project where we will be using Ethernet communications to talk to PowerFlex 525 and 755 drives.
2 questions:
1) I have 1 EN2T that has the IP that I select for communicating with the processor(Slot 1) and 1 EN2T that is connected to a remote rack (Slot 2). Both of these are on the same network. Do I need another EN2T for the drives or do I connect one of those to a switch and use that? I don't have anymore empty slots in the Local rack, but I do have space in the remote rack. If I need another card can I put it in the remote rack?
2) When I right-click on either one of the EN2Ts and click "new module" I see several options for the 755 drive, but I don't see an option for the 525 drive. How can I set up the 525 drive?
Thanks for the help.
Here's what I have:
Controller: ControlLogix 5562, 1765-L62
Software: RSLogix 5000
Revision: 20.11
I have a project where we will be using Ethernet communications to talk to PowerFlex 525 and 755 drives.
2 questions:
1) I have 1 EN2T that has the IP that I select for communicating with the processor(Slot 1) and 1 EN2T that is connected to a remote rack (Slot 2). Both of these are on the same network. Do I need another EN2T for the drives or do I connect one of those to a switch and use that? I don't have anymore empty slots in the Local rack, but I do have space in the remote rack. If I need another card can I put it in the remote rack?
2) When I right-click on either one of the EN2Ts and click "new module" I see several options for the 755 drive, but I don't see an option for the 525 drive. How can I set up the 525 drive?
Thanks for the help.