Hi I am new to the forum, I have an old Alpine bar feeder with a GE Fanuc micro 90 plc, that was programed with Versa pro I think , but I have
GE Machine edition 7.0. I had to replace the plc with a new one, when I copied the program to the new plc I got this error (8036) I changed it to a warning instead of a error, but the plc goes into run but I cant use the hand held HMI ,I think the address problem is stopping it. I read on one of the old posts back in May 2019 that a user had the same problem, can anyone you help, thanks
GE Machine edition 7.0. I had to replace the plc with a new one, when I copied the program to the new plc I got this error (8036) I changed it to a warning instead of a error, but the plc goes into run but I cant use the hand held HMI ,I think the address problem is stopping it. I read on one of the old posts back in May 2019 that a user had the same problem, can anyone you help, thanks
Last edited: