Baila_Shah
Member
Hi all,
I have connected the QuickPanel+ with Modbus TCP/IP comm module along with other I/O modules. The software I am using for PLC coding is Proficy Machine Edition 8.6. Today I wanted to check the effect of the communications failure on the setup and I was surprised to see that the outputs remained on even after communication was terminated.
Has anyone came across a similar issue? Could anyone of you please suggest how to make the outputs go off after the communication failure is encountered?
Thanks in advance.
Best Regards,
I have connected the QuickPanel+ with Modbus TCP/IP comm module along with other I/O modules. The software I am using for PLC coding is Proficy Machine Edition 8.6. Today I wanted to check the effect of the communications failure on the setup and I was surprised to see that the outputs remained on even after communication was terminated.
Has anyone came across a similar issue? Could anyone of you please suggest how to make the outputs go off after the communication failure is encountered?
Thanks in advance.
Best Regards,