Dear all,
I have this sort of registers being accessed in a PLC ladder diagram that I am looking at these days.
M8000
-----| |------[MOV R900Z0 D400]
~~~~~
M8000
-----| |-------[MOV D301 Z0]
What are these R900Z0 and Z0 registers? Where can I find the section about these in the fx-3u programming manual? It seems Z is used for some pointer operation but that's all I could find.
Best regards.
I have this sort of registers being accessed in a PLC ladder diagram that I am looking at these days.
M8000
-----| |------[MOV R900Z0 D400]
~~~~~
M8000
-----| |-------[MOV D301 Z0]
What are these R900Z0 and Z0 registers? Where can I find the section about these in the fx-3u programming manual? It seems Z is used for some pointer operation but that's all I could find.
Best regards.