Help with fault codes

one_plc_for_everyone

Member
O
Join Date
Jun 2021
Location
Turlock
Posts
2
At random times, I am getting the following faults. Type 14 Code 01 and Type 14 Code 09. Turning the key resets the fault and I can run again normally until it happens again. I have checked the knowledge base and looked on the forums, but I am getting some conflicting information. Is there anything you guys can tell me? Apologies in advance, I'm a PLC noob. Controller is a Compact Guardlogix 1759-L43S.

Posted are some images and gifs.


p4LLGYJ.png



e2cgRiO.png



RpfCI6X.jpg



https://i.imgur.com/GFJB8md.gifv

https://i.imgur.com/wiyaKAM.gifv
 
Last edited:

Similar Topics

Q
Redundancy Fault - Urgent Help needed
Hi all, We are facing synching issues with redundancy module, where the Primary is ending up with disqualified secondary. Normally this would...
Replies
2
Views
625
Ken Roach
Ken Roach
K
Micro820 Fault Loop Help!
Hello all! I come asking if anyone has had this situation. I have a Micro820 controller that sits idle for some long periods (I use it to count...
Replies
5
Views
1,327
kstiles1499
K
Y
1769-L16-B1BB Unrecoverable Fault, HELP
Dear all, First post on the forum. my supervisor and I have a 1769-L16-B1BB acting up in the field. We decided to program and send an identical...
Replies
8
Views
2,441
ASF
A
J
Default Gateway Help
Hello there! I am extremely new to the field (about 1 month), and unfortunately (as so often happens to us Engineers!) I am picking up where the...
Replies
3
Views
1,356
Operaghost
Operaghost
D
Kinetix 6000 fault capturing help
Hey all, First time poster looking for a little help. I have a Kinetix 6000 drive that I am capturing faults for in RSLogix but I need some help...
Replies
0
Views
958
digitalnametag
D
Back
Top Bottom