I want to measure the level of water inside a closed st.st tank with an over flow opening in the top of the tank
at the begining of filling the tank with fresh water the level measurement process being so good.
But after filling the tank, the water needs to be heated to 90 degrees, during the heating process iam noticing that the level of the water is increasing due to the vapour pressure which indicates to a fake level reading.
Is there any tips to overcome this problem?
at the begining of filling the tank with fresh water the level measurement process being so good.
But after filling the tank, the water needs to be heated to 90 degrees, during the heating process iam noticing that the level of the water is increasing due to the vapour pressure which indicates to a fake level reading.
Is there any tips to overcome this problem?