gitargr8
Member
I'm wondering if anyone out there has successfully gotten GE's IGS driver to talk to a Honeywell 620 PLC. I believe that the old SCADA used the EIM driver to talk to an ELPM 620-0073C card, through a serial to 10 base t Ethernet transceiver. The problem is I don't believe EIM is supported on Windows 7 64bit.
I had read somewhere that the Honeywell uses Modbus RTU, but when I add this driver type in IGS, there is no option for a Honeywell PLC.
I tried searching GE's forums, but came up empty. Any input would be greatly appreciated.
~Ryan
I had read somewhere that the Honeywell uses Modbus RTU, but when I add this driver type in IGS, there is no option for a Honeywell PLC.
I tried searching GE's forums, but came up empty. Any input would be greatly appreciated.
~Ryan