JordanCClark
Lifetime Supporting Member
Hi guys!
In the Ultra3000, you could use an input to switch between position and current modes. Is there any similar functionality in Kinetix Integrated Motion?
My application is something along the lines of:
So is there a better way?
In the Ultra3000, you could use an input to switch between position and current modes. Is there any similar functionality in Kinetix Integrated Motion?
My application is something along the lines of:
- Move to a part under test in position mode.
- Switch to torque mode to simulate a weight
- Switch back to position mode to get ready for the next part.
So is there a better way?