sheryl86_ann
Member
Greetings!
May I ask some help regarding this condition: I am currently involve in PLC programming of a certain machine. One thing that needs to be modified is this one:
When the machine is at automatic operation and was suddenly stop, after ON again to automatic operation, it must continue to finish its 1 whole cycle NOT to start again to its 1st step during start up because theres a tendency that a certain product will just be wasted.
I am thinking about latching but how would I do it. I am still very fresh on this programming matter. Can anyone suggest? Any help? I am using Mitsubishi FX3u-80mt plc.
Thank you very much!
Sincerely,
sheryl
May I ask some help regarding this condition: I am currently involve in PLC programming of a certain machine. One thing that needs to be modified is this one:
When the machine is at automatic operation and was suddenly stop, after ON again to automatic operation, it must continue to finish its 1 whole cycle NOT to start again to its 1st step during start up because theres a tendency that a certain product will just be wasted.
I am thinking about latching but how would I do it. I am still very fresh on this programming matter. Can anyone suggest? Any help? I am using Mitsubishi FX3u-80mt plc.
Thank you very much!
Sincerely,
sheryl