Rouxgaroux
Member
Hi, I’m new to the forum and very new to PLCs. I’m working on a project in LogicxPro and have an issue. Any help would be appreciated.
What I want my program to do is have the idle light on when it’s in RUN mode. Once I press start I want pump 1 and 2 to fill. Pump 1 fills to 150 and pump to fills to 50. Once the pumps are done I want the full light on and the mixer and heater to turn off. Once the thermostat reaches the specified number I want both the heater and mixer to turn off, the full light off, and pump 3 to empty the tank. Then the idle light turns back on.
Ideally, I’d like to restart the process by pressing start again.
Right now it works until pump 3 empties the tank. Once it’s empty the heater turns back on and the full light is still on.
Last edited: