croakus
Member
I went through beaucoup Google pages looking for something similar to a motorized tie rack to feed small parts into a production cell. I ran across a lot of interesting stuff, but nothing industrial in nature.
I could roll my own with a small geared motor, chain, and a limit switch but am hoping there may be something out there a little more off the shelf.
Optimally it would hold 40-60 parts about 2"x1/2"x24" that weigh about 1/4lb. each.
Any ideas where I can look?
TIA,
Mike
I could roll my own with a small geared motor, chain, and a limit switch but am hoping there may be something out there a little more off the shelf.
Optimally it would hold 40-60 parts about 2"x1/2"x24" that weigh about 1/4lb. each.
Any ideas where I can look?
TIA,
Mike