turbohamad
Member
Hi Guys
how can i calculate the output parameters are given below
In=700
wlag=0.3
timing mode=0
i can not understand the function of LPF.
help describe that
"The LPF instruction attenuates signals that occur above the configured cutoff frequency. This instruction is typically used to filter out high frequency "noise" or disturbances that originate from either electrical or mechanical sources."
how can i determine the configured cut off frequency?
please help me?
how can i calculate the output parameters are given below
In=700
wlag=0.3
timing mode=0
i can not understand the function of LPF.
help describe that
"The LPF instruction attenuates signals that occur above the configured cutoff frequency. This instruction is typically used to filter out high frequency "noise" or disturbances that originate from either electrical or mechanical sources."
how can i determine the configured cut off frequency?
please help me?