hinddhindsa
Member
I have a Twido PLC TWDLCAA224DRF for 3 booster pumps application,With TM2AMM3HT analog input Module connected.
I have another HMI Magelis XBT-N400. It is connected to my twido PLC through Cable XBTZN999 + XBTZ978. I have Twido suite software. Through tsxpcx1031 communication cable i am able to see anitmated program in programming Mode. If i want to save this program in my laptop and make any changed in the program. How can i do that ?.
There are three things shown by the programmer on HMI.
I AM getting error #203 Dialog table reading impossible.
why that error is coming,How to cure that Error. ?.
LINE PRESSURE -- 0.0 BAR.
LINE FLOW -- M3/H. (here it shows ###.)
SET PRESSURE -- BAR.
and from 3 pumps only 1 pump is turning ON,Other pumps remains off only. when again pressure goes down then next pump start. so i mean only 1 pump runs.
I have another HMI Magelis XBT-N400. It is connected to my twido PLC through Cable XBTZN999 + XBTZ978. I have Twido suite software. Through tsxpcx1031 communication cable i am able to see anitmated program in programming Mode. If i want to save this program in my laptop and make any changed in the program. How can i do that ?.
There are three things shown by the programmer on HMI.
I AM getting error #203 Dialog table reading impossible.
why that error is coming,How to cure that Error. ?.
LINE PRESSURE -- 0.0 BAR.
LINE FLOW -- M3/H. (here it shows ###.)
SET PRESSURE -- BAR.
and from 3 pumps only 1 pump is turning ON,Other pumps remains off only. when again pressure goes down then next pump start. so i mean only 1 pump runs.