master and slave simulation problem

mohamed abd el raouf

Member
M
Join Date
Mar 2017
Location
6 October
Posts
69
hi to all ,
i'm trying to do a master and slave system using DP ( HW config as follow )
15x7kly.jpg

zv5y8o.jpg

e6f0xe.jpg

2w49ws9.jpg

but when i simulate them i could not read from master or slave
2cncdnr.jpg
 

Similar Topics

A
Kinetik 300 -2097-V33PR3 Master and Slave Configuration
Hi i using Kinetik 300 2097 driver control by EIP with using move absolute and incremental for motion , but i want to add same driver and motor as...
Replies
0
Views
5
Ansonkiek
A
A
MODBUS MASTER/SLAVE PCS7 9.1 SP1
Does anyone have an example project of the cm ptp ET200 SP HA with 410-5H DCS (PCs7 9.1 SP1) for MODBUS MASTER/SLAVE communication ?
Replies
2
Views
130
Arun Kumar Yadav
A
B
AOI to sync slave controller clock to master controller clock messaging question
Hello, I am trying to create an AOI that will retrive the clock datetime bits from a master plc through a generic message read instruction and...
Replies
2
Views
499
Contr_Conn
Contr_Conn
A
cqm1 slave ،hmi delta master
Hello, I know little English, I want to use 4 plc cqm1 as slave (modbus), and hmi delta as master. Unfortunately, I cannot establish rs485...
Replies
3
Views
589
parky
P
D
Trouble with Modbus slave/Master in BCS Tools/iX developer
Hello, I am quite new to PLC programming. The master would be a Beijier HMI (iX T12B SC) and the slave a Beijier Nexto (XP340). I have...
Replies
12
Views
3,240
DCollis
D
Back
Top Bottom