spaceacealpha
Member
Hello, I'm trying to connect a ML1000 Analog to a 1761-NET-AIC and running a 485 cable over to a SLC 5/03's 1761-AIC. I'm using the Micrologix as a thru-gate for analog information from a Keyence Laser over to the 5/03. However, the most I ever did with 485 networks is gut them and replace with DH+.
I hooked up all the wiring and the jumpers according to the manual. I first hooked up the 5/03's AIC and attached my laptop to its 485 port with a PIC and I could see my 5/03 through it. I looked at the NET-AIC on the ML1000 side and it's lit up like a christmas tree. I hook up the ML1000 with the specified cable and I lose the 5/03 completely and never see the ML1000. So I went to the NET-AIC side and unhooked the 485 to the SLC, attached my DF1 cable and start talking fine through the NET-AIC to the ML1000. I set up the ML1000 to node 2 DH485 at 19.2k but the DF1 port is saying its node 1 at 9.6k. Also I have S:0/10 set to 1. Can someone tell me how to set these things up right?
I hooked up all the wiring and the jumpers according to the manual. I first hooked up the 5/03's AIC and attached my laptop to its 485 port with a PIC and I could see my 5/03 through it. I looked at the NET-AIC on the ML1000 side and it's lit up like a christmas tree. I hook up the ML1000 with the specified cable and I lose the 5/03 completely and never see the ML1000. So I went to the NET-AIC side and unhooked the 485 to the SLC, attached my DF1 cable and start talking fine through the NET-AIC to the ML1000. I set up the ML1000 to node 2 DH485 at 19.2k but the DF1 port is saying its node 1 at 9.6k. Also I have S:0/10 set to 1. Can someone tell me how to set these things up right?