Thor Hammer
Member
I am reading and writing between two ML1400 PLC's. Previous versions worked just fine. Now all of a sudden I am getting an ERR message for only a few of the MSG files but not all?
Hmm, last time I downloaded the program to PLC ONE last week remotely I got a popup message before download occurred saying something about Channel 1 being different or something along those lines. I proceeded anyways. Not sure if that was the issue. I thought it was because a fellow programmer got a hold of the program and logged on remotely himself, then sent the code back to me. Could he have changed something in the communications to cause this problem?
I have looked over all previous versions of this program for PLC ONE (REV14A) and PLC TWO and nothing has changed. Channel 1 config is the same as before. Not sure what is going on and desperately need assistance on this one.
Hmm, last time I downloaded the program to PLC ONE last week remotely I got a popup message before download occurred saying something about Channel 1 being different or something along those lines. I proceeded anyways. Not sure if that was the issue. I thought it was because a fellow programmer got a hold of the program and logged on remotely himself, then sent the code back to me. Could he have changed something in the communications to cause this problem?
I have looked over all previous versions of this program for PLC ONE (REV14A) and PLC TWO and nothing has changed. Channel 1 config is the same as before. Not sure what is going on and desperately need assistance on this one.