Hemanthapte
Member
Dear All,
I am implementing Mitsubishi Protocol format 4 for a HMI to communicate with FX -3G and FX-3U series PLCs. I am not able to read ER address range using protocol (dedicated) format 4.
I am not find any Command to use for the same. Is it possible to read these Extended file registers (ER) using format 4 protocol?
thanks a lot.
with regards,
Hemanth.
I am implementing Mitsubishi Protocol format 4 for a HMI to communicate with FX -3G and FX-3U series PLCs. I am not able to read ER address range using protocol (dedicated) format 4.
I am not find any Command to use for the same. Is it possible to read these Extended file registers (ER) using format 4 protocol?
thanks a lot.
with regards,
Hemanth.