allscott
Member
- Join Date
- Jul 2004
- Posts
- 1,332
I just received a machine with a mircrologix 1200 PLC in it. I went to connect to it using the cable that I have been using for the 1500 1761-clb-pm02, the right angle version.
This should be the right cable for the 1200 as well but it doesn't fit. The socket is the same but the connector body is too big to fit.
Has anyone else run across this? I'm about to take a knive to the cable I have to trim it to make it fit.
Or am I completely out to lunch.
This should be the right cable for the 1200 as well but it doesn't fit. The socket is the same but the connector body is too big to fit.
Has anyone else run across this? I'm about to take a knive to the cable I have to trim it to make it fit.
Or am I completely out to lunch.