Matthias von Zorn
Member
Im currently adding ethernet comms to a system ive been hired to modify. The current system has a ML1100 and a slc 5/05. I need to do a write from the ml to the slc. In setting up the msg command in the ladder, I noticed that when you select ethernet on the ML there is no place to put the target IP address. It does appear that you can enter it into the Multihop section. This doesnt seem right to me tho. Is this the correct way to msg to the slc?
What about doing a read from the slc to the ml? Format it the same as if I was targeting a slc? Thanks
matt
What about doing a read from the slc to the ml? Format it the same as if I was targeting a slc? Thanks
matt