agentnumber2
Member
Hi Gentlemen,
I was hoping to perform a mathematical operation every scan on the ML1100, and I cannot seem to get it to work. Just to test it, I have a single rung that is taking the input from AI Channel 0 and multiplying it by itself, the the rung below it adding up the squared values (attempting to get an RMS value... eventually).
Do I need to put a special NC contact before the operation, or should I just leave it as a rung with the mathematical operation?
Thanks!
I was hoping to perform a mathematical operation every scan on the ML1100, and I cannot seem to get it to work. Just to test it, I have a single rung that is taking the input from AI Channel 0 and multiplying it by itself, the the rung below it adding up the squared values (attempting to get an RMS value... eventually).
Do I need to put a special NC contact before the operation, or should I just leave it as a rung with the mathematical operation?
Thanks!