kslow64
Lifetime Supporting Member
I have an Atlas Copco Power Focus 4000 and a MicroLogix 1400. I need to capture the Final Torque and Final Angle from the PF to the ML1400. The PF has EIP capability.
When I spoke with Atlas Copco tech support they told me that they did not provide programming or setup examples for PLCs. I have no idea what the Data Table address should be on the Target Device. (see image) On top of that I haven't done Logix500 programing
in well over a decade.
I am currently getting these errors:
ERROR: Target address must not be indexed or specified to the bit level!
ERROR: No Multihop Path Entries Exist
Any help would be greatly appreciated!
Kelly
When I spoke with Atlas Copco tech support they told me that they did not provide programming or setup examples for PLCs. I have no idea what the Data Table address should be on the Target Device. (see image) On top of that I haven't done Logix500 programing
in well over a decade.
I am currently getting these errors:
ERROR: Target address must not be indexed or specified to the bit level!
ERROR: No Multihop Path Entries Exist
Any help would be greatly appreciated!
Kelly