Noob guide for Siemens MicroBox PC?

parky said:
So had to order S7 V5.5 and they would not take back the TIA as it had been opened, an expensive mistake.
Click to expand...


As a retro-active FYI:



There is a COMBO license option available, where the TIA license covers both new and old, if you knew you needed both. It was(is?) not nearly as easy to order as it should be.
 

Similar Topics

J
Sorry for noob question: hmi / terminal settings
I work in a field where our plc and hmi are constantly being powered fully off and on daily before being sent out. I am new to the world of plc...
Replies
5
Views
962
IO_Rack
IO_Rack
B
A Noob question…24v
Please laugh… but can I take 24volts from an IO module and wire it straight into its own input card to simulate an input….?
Replies
5
Views
1,262
drbitboy
drbitboy
theColonel26
FT View noob: Which Edition do I install?
I need to be able to open a customer's FT View project and make any changes if necessary. Which one do I need??? :hmmm: I don't want to have...
Replies
10
Views
2,593
Operaghost
Operaghost
B
Complete noob with load cells
Hello all, i will start off by saying i know nothing about load cells, i want a converter/amplifier to output a 4/20mA signal from a load cell...
Replies
14
Views
5,402
Bobobodopalus
B
Y
Noob help with Analog O/Ps
Hi All, I don't have a ton of experience with PLCs yet, so I appreciate any feedback I can get. What I am doing is using an Omega FMA1816A mass...
Replies
7
Views
1,826
drbitboy
drbitboy
Back
Top Bottom