patrickser
Member
I am trying to figure out a way to dynamically change PLC programs through the FINS protocol (specifically the Program Area /Clear/Read/Write commands. I found the command information here: http://goo.gl/lhlv6 in section 5-3-11. I am trying to find an example of this command to get started with.
I am wanting to do this to eliminate CX-Programmer from being needed to upload new programs to the PLC. The intended result is to be able to use CX-Programmer only to create the ladder logic files and than use a FINS protocol script to upload them to a PLC.
Any help or advice would be greatly appreciated. I am new to the PLC world.
I am wanting to do this to eliminate CX-Programmer from being needed to upload new programs to the PLC. The intended result is to be able to use CX-Programmer only to create the ladder logic files and than use a FINS protocol script to upload them to a PLC.
Any help or advice would be greatly appreciated. I am new to the PLC world.
Last edited: