justinfromPA
Member
Im on site, there was water damage in the cabinet. Trying to see what i can do
Right now here is there. I can see all inputs, and LEDs work. 24vdc is being supplied to every card.
-In the prog, i can see the status of every card is "Running"
-Controller in Run mode
-Ive powered cycled, as well as switched from Prog to run multiple times
-Ive attempted forcing with no luck.
-Replaced one output card with no change
-its almost like the program isn't running through the routines although its in run mode
Right now here is there. I can see all inputs, and LEDs work. 24vdc is being supplied to every card.
-In the prog, i can see the status of every card is "Running"
-Controller in Run mode
-Ive powered cycled, as well as switched from Prog to run multiple times
-Ive attempted forcing with no luck.
-Replaced one output card with no change
-its almost like the program isn't running through the routines although its in run mode