sweety616
Member
I have a panelview 600 on ethernet network. I built the program for it using panelbuilder32 but the tags I created in the program should use addresses from a program currently run on a SLC 5/03 on DH485 network. How do I get around this?
Also on another ethernet panelview 600, I am getting a "check your terminal for compatibility" error while downloading a program. What do I need to check? Is there a manual on the internet somewhere for Panelview 600. I received a link before but it did not work. I would also like a troubleshooting guide
Also on another ethernet panelview 600, I am getting a "check your terminal for compatibility" error while downloading a program. What do I need to check? Is there a manual on the internet somewhere for Panelview 600. I received a link before but it did not work. I would also like a troubleshooting guide