For a thermoset molder I am looking for a vision system that can monitor part removal from a mold. The mold temps can range anywhere from 300 to 450 degrees fahrenheit. Their issue is that the operator will occasionally forget to remove the part and add more material and start the next cycle. This causes them a major issue and mold damage that takes a lot of money and time to repair on top of their loss of production. I have found moldwatcher from avalon systems (https://avalonvisionsolutions.com/solutions/moldwatcher/) but I am trying to see if anyone knows of a solution that would be less expensive. I would be intergrating into the press that is being run with 1769-L30ER version 30.011 and a safety module 440C-CR30-22BBB.
Thanks
Thanks