I have set-up an integer data file "N50" with 100 elements. There is nothing being written to these locations from my logic. While on-line, I am attempting to write my own values in to these locations (Ie. 1, 2, 3, 4, 5 etc. etc.) by going in to the data table and double clicking on these elements. But the value reverts back to 0. How are my values getting overwritten and not saved in the data table?
I would like to have a table of my own integer data put in to a data table and have it available anytime the PLC is powered on. (Retentive data). How do I go about getting this done?
Confused!
Thx.
I would like to have a table of my own integer data put in to a data table and have it available anytime the PLC is powered on. (Retentive data). How do I go about getting this done?
Confused!
Thx.
Last edited: