I am needing to swap a L80 processor to a later series. I would like to reset the scan time and then record, and compare the difference between the old vs the new. I went into the processor status and then scan time but I am not sure how I would need to reset and then verify the scan time.
Second. I will be configuring the new processor with bootp. Where would I find the MAC address to know that I am clicking on the right device to configure. I see a SN # on this module that says SN 007D7D5E, but I dont see anything that specifies the MAC.
Thanks
rm
Second. I will be configuring the new processor with bootp. Where would I find the MAC address to know that I am clicking on the right device to configure. I see a SN # on this module that says SN 007D7D5E, but I dont see anything that specifies the MAC.
Thanks
rm