Mel_24
Member
Hi all
Was wondering if you guys were able to help. I am onsite trying to program a 440C-CR30-22BBB Safety relay. Using the following pdf and trying to follow the instructions to add the CR30 Safety Relay to the I/O configuration. (Chapter 13, pg 114).http://literature.rockwellautomation.com/idc/groups/literature/documents/um/440c-um001_-en-p.pdf
Problem is that I can't change the module to revision 9, even after I downloaded the AOP for version 9.004 from the Rockwell download center.
Any ideas on how to do this would be awesome as i am wasting too long on this at the moment.
Was wondering if you guys were able to help. I am onsite trying to program a 440C-CR30-22BBB Safety relay. Using the following pdf and trying to follow the instructions to add the CR30 Safety Relay to the I/O configuration. (Chapter 13, pg 114).http://literature.rockwellautomation.com/idc/groups/literature/documents/um/440c-um001_-en-p.pdf
Problem is that I can't change the module to revision 9, even after I downloaded the AOP for version 9.004 from the Rockwell download center.
Any ideas on how to do this would be awesome as i am wasting too long on this at the moment.